How do you adjust the carburetor on a TTR 125?
How do you adjust the carburetor on a TTR 125?
If you want to adjust the MIXTURE (since you just put in new jets) the screw is underneath the front of the carb. So look from underneath and you will see it. Start at 1 1/2 or 2 turns out,warm engine, adjust for highest idle then turn back in 1/2 turn. More than 3 1/2 turns go to bigger idle jet.
How do you adjust the idle on a TTR 125?
58 second suggested clip1:453:17Idle Screw / Fuel Screw – TTR 125 Won’t Idle – Understanding LocationsYouTubeStart of suggested clipEnd of suggested clipBack the auto screw out a few turns because you want your idle screw to be your idle adjustment thatMoreBack the auto screw out a few turns because you want your idle screw to be your idle adjustment that air fuel screw should be at about two turns out roundabouts depend on your jetting and elevation.
Why is my TTR 125 leaking gas?
It has to be a sealing problem with the needle and seat. I suspect that the solution will be obvious when you take the bowl off. Always blow in the fuel intake and move the float up and down to check for sealing before you put the bowl back on.
What size carb is on a TTR 125?
Additional Information
| Specification | Details |
|---|---|
| Carburetor Size | 24mm |
| Carburetor Type | Round Slide |
| Carburetor Mount | Spigot |
| Carburetor Intake Bell Diameter | 44mm |
How do you adjust the idle on a ttr50?
52 second suggested clip4:576:33Yamaha TTR50 Idle Set Screw Adjustment – YouTubeYouTube
How do you adjust the idle on a Yamaha TTR 90?
Stand in front on the right side bend over and across the front wheel. The screw is on the inside and just behind the body of the carb. Once you’ve done it once you can literally do it with your eyes closed. Look in your manual it will help a little.
Where is the idle screw on a TTR 90?
How do you adjust the float on a TTR 125?
56 second suggested clip8:0514:40Fixing a leaky carburetor ! 2009 Yamaha TTR 125 | Float / NeedleYouTube
Can you lower a ttr50?
The easiest thing to do is to remove the seat and trim it down.