How do you reset the radio on a 2014 Jeep Cherokee?

Push and hold the volume and two knobs at the same time for about 10 to 20 seconds until the radio power is off. Once the system shut off it will quickly turn back on and take about a minute or so to fully come back online.

How do you reset the radio on a 2014 Jeep Wrangler?

Resetting the Jeep Wrangler UConnect Radio System

1. Start your vehicle and press down on the ‘voice recognition’, and ‘phone’ buttons located on the steering wheel.
2. Turn off your vehicle and wait for the UConnect display to go completely black.
3. Afterwards, open and close the driver’s door and restart the vehicle.

How do I reset my UConnect 2014 Jeep?

Uconnect® Hard Reset Procedure

1. Press the hot and coup up and down buttons simultaneously for at least five seconds.
2. Scroll through the menu that pops up and select the choice prompting you to reset factory defaults.
3. Once selecting this option, wait roughly 30 seconds while the system reboots.

How do I unfreeze my Jeep radio?

To do a soft reboot of Your touch screen in Your 2018 Jeep Grand Cherokee You’ll need to hold down the enter and volume buttons for 15 to 25 seconds. After this time has passed the screen will flash and then it should come back on and work like normal.

How do I reset my Jeep Cherokee?

How to Reset the Jeep Grand Cherokee Service Required Message

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.

How do you reset the radio on a 2015 Jeep?

When You open the hood, make sure that it is properly latched so that it doesn’t fall on You. Then, go ahead and disconnect the battery. You will then wait from around 10 to 20 minutes, the longer the better. When those 20 minutes have passed, go ahead and reconnect that battery.

How do I get the code for my jeep radio?

PROCEDURE TO OBTAIN ANTI-THEFT CODE:

1. Call 1-800-448-0944.
2. Request anti-theft code.
3. State dealer code.
4. State radio serial number.
5. State VIN.
6. The 4-digit anti-theft code will be provided.

How do you fix a frozen UConnect screen?

Hold down the knobs for 10 – 20 seconds. After holding down the knobs, the screen should flash your vehicle brand name and then go dark. After a few moments the brand name will return, the system will reinitialize, and it will return you to the main UConnect screen.