How do you use GlitterBug?

That’s where GlitterBug Powder comes in. Sprinkle a commonly touched item such as a doorknob, sign-in folder, work surface, etc, with the Powder. It is invisible to the naked eye. Allow the students to interact with the surface for a while, and then track the spread of the Powder with a UV light.

What is GlitterBug potion?

If you prefer to wash your hands using soap and water, GlitterBug Potion is for you! GlitterBug Potion, however, is a real product used to teach good handwashing technique. The potion consists of a UV fluorescent powder mixed in a special hand lotion.

What is the standard for hand washing?

Wet your hands with clean, running water (warm or cold), turn off the tap, and apply soap. Lather your hands by rubbing them together with the soap. Lather the backs of your hands, between your fingers, and under your nails. Scrub your hands for at least 20 seconds.

How do you do a clinical hand wash?

1. Wet your hands with water.
2. Apply enough soap to cover your hands.
3. Rub your hands together.
4. Use 1 hand to rub the back of the other hand and clean in between the fingers.
5. Rub your hands together and clean in between your fingers.
6. Rub the back of your fingers against your palms.
7. Rub your thumb using your other hand.

How does Glo Germ work?

It’s Easy to Use! The liquid or gel and the powder contain the plastic simulated germs, and the lamp illuminates them to test the effectiveness of your (and your workers’) practices. For handwashing training, Glo Germ™ Liquid is rubbed onto one’s hands like lotion. One’s hands and the surfaces appear clean.

How long should clinical hand washing take?

Guidelines for Hand Hygiene The hands should be rubbed together for 15 – 20 seconds so that the soapy water comes into contact with all surfaces of each hand, (See figure 1).

What can I use instead of Glo Germ?

glitter glue
use glitter glue instead of Glo Germ. The best results should be after using soap for at least 20 seconds.

How do I get rid of Glo Germ?

Surface Cleaning

1. Lightly dust a small amount of Glo Germ powder over an entire surface area.
2. Clean the surface until all visible powder disappears.
3. Pass the UV lamp over the surface; the remaining traces of powder will glow on the areas that weren’t washed thoroughly.